Twist Rubber-Powered Model Kit
- Bestseller

Flight-Depot.com OHG

aeronaut

Flight-Depot.com OHG

Flight-Depot.com OHG

Flight-Depot.com OHG
Delivery time 2 to 5 days
21,90 € incl. 19,00 % VAT, plus shipping
Twist Rubber-Powered Model Kit
Your Price
21,90 €
Prices including 19 % VAT.
plus shippingDelivery time 2 to 5 days
Item No.: AN123200
Twist Rubber-Powered Model Kit
Beginner's Model Kit for a Rubber-Powered Model Aircraft
The Twist model is launched to an initial flight altitude using a rubber motor drive, before transitioning into a glide.
Thanks to the standard Jedelsky construction of the wings, the Twist by Aeronaut boasts excellent flight characteristics.
All balsa and plywood parts are pre-cut, allowing you to start assembling immediately.
After a short construction time, the pilot is rewarded with long flights. We recommend the Twist for beginners. The kit is ideal for school workshops, after-school programmes, and clubs.
Contents
- Pre-cut balsa and plywood parts
- Propeller
- Rubber motor
- Decorative sheet
- Illustrated step-by-step instructions at a 1:1 scale
Product Features
- Wingspan 690 mm
- Length 510 mm
- Flight weight approx. 85g
- Wing loading approx. 13.3 dm²
Spare Parts
- Replacement Rubber for Twist
- Sport Rubber for Twist (we recommend the FAI competition rubber for longer flight times, available in our online shop)
FAQs
How durable are the Boogie and Twist rubber-powered models?
Boogie and Twist, the two rubber-powered models from aeronaut, are light yet durable. The fuselage strips are made from break-resistant pine rather than balsa. The models fly very well and are therefore also popular for school workshop projects. Our sport rubber can be used for longer flight times.
In general, model aircraft that are intended to fly well have to be built lightly, so careful handling is part of using them. When launching the model, it should not be thrown too hard, but at a slightly upward angle.
Is wood glue included in the kit, or is additional adhesive required?
Wood glue is not included in the kit. We recommend Ponal Express. Cyanoacrylate adhesive can also be used as an alternative.
Can the model be painted without affecting the wood or its flight characteristics?
The wood can be coloured, preferably with coloured felt-tip pens. It is important that moisture does not warp the wood, as could happen with watercolours, and that the model does not become too heavy.
Alternatively, thin typewriter paper can be coloured, cut out and then glued to the model using UHU Flinke Flasche.
How is the wing attached to the fuselage?
The wing is attached to the fuselage using a rubber band. This classic method of attaching the wing on functional flying models is simple and has proven itself in practice.
How are the wing and rubber motor installed correctly?
The retaining rubber bands are stretched crosswise over the wing and attached to the two round dowels below the leading and trailing edges of the wing. In the plan, the round dowels are numbered 14 and marked in red.
The rubber motor is 2 m long. A few millimetres more or less when tying the knot are not important. When the rubber motor is attached to the tail and propeller as described in the instructions, four strands of rubber run through the fuselage. When relaxed, the rubber may rest inside the fuselage.
How long does construction take, and can the model be completed in a two-hour workshop?
With practice and the use of cyanoacrylate adhesive, a short build time is possible. However, completing the assembly within two hours is very difficult for an inexperienced model builder. In that case, a simpler model such as the Flying Machine is more suitable.











































